LED Status - PowerTool Classic

This information is for PowerTools purchased prior to November 2017

For later edition Bluetooth LE PowerTools, please read this article

The PowerTool LED’s can be either Green, Orange or Red.

Depending on the LED’s state - solid or flashing correlates to the state of the PowerTool. Use the table below to diagnose the state of the PowerTool at any time.

Example:

In this picture the LED is Orange. In this state, the unit is connected to an iOS device without the GymAware App in use.

LED STATUS	WHAT DOES IT MEAN?
Green	Connected to an iOS device and App in use.
Green Flashing	Waiting for a connection - trying to pair
Orange	Connected to an iOS device but the app isn’t in use
Orange Flashing	Attempting auto-connect to an iOS device without the App being in use.
Steady Red and Flashing Green	Bluetooth communications problem and attempting to reconnect. Switch off Bluetooth on devices that are not connected to a Bluetooth peripheral.  Re-set the PowerTool and retry.
Red Flashing	The battery is going flat and needs charging
None	Sleep mode - pull the tether to awaken the PowerTool.  If no LED’s flash after pulling the tether this could mean the battery is flat or faulty.
Green/Orange/Red	Try a hard reset. Contact Kinetic if this does not fix the issue.
Steady Orange, flashing Red and Green, repeated beeping, yellow charge indicator.	The unit is on charge and the battery voltage is at a level that causes this behaviour. Allow the charging to continue for several minutes and the behaviour will cease.